PrintStar
Printing System Specifications |
| Printer
Type- |
Large
character ink jet printer |
| Character
Height- |
.75”
(1.9cm) in 7 x 5 matrix; .5” (1.3cm) in 5
x 5 matrix, or .5” (1.3cm) in 7 x 5 matrix;
.375” (1cm) in 5 x 5 matrix, or .375 (1cm)
in 7 x 5 matrix; .25 (.6cm) in 5 x 5 matrix |
| Character
Set- |
61
character ASCII set |
| Print
Speed- |
20
feet/minute (6.1 m/minute) to 200 feet/minute (61m/minute)
line speed; optional extended character width firmware
allows for print speeds slower than 20 feet/minute |
| Message
Length- |
60
character per message; 64 memory locations |
| Communication- |
RS-232C,
9600 baud, 8 data bits, 1 start, 1 stop, Asynch |
| Software
Features- |
24-hour
clock, Julian date, counter, lot counter |
| Operating
Features- |
Dot
size, print delay, character width, photocell on/off,
invert print, reverse print, purge routine |
| PrintStar
Exchange Program- |
Eliminates
the need for costly service calls and minimizes
downtime; troubled printheads and components can
be replaced in less than 5 minutes |
| Controller
Dimensions- |
12”
(31cm) H x 12” (31cm) W x 5.25” (13cm)
D |
| Controller
Weight- |
10.5
lbs. (4.8kg) |
| Printhead
Dimensions- |
3”
(7.6cm) H x 1.6” (4.1cm) W x 7” (17.8cm)
L; dimensions are for the printhead only –
an additional 3” (7.6cm) is needed for the
ink line and printhead cabling which extends from
the back of the printhead |
| Product
Sensor- |
Diffuse
beam photocell (24v) or hardware sinking signal |
| Electrical
Requirements- |
110/120
VAC, 50/60Hz, 1.6 amp |
| Cabinet
Construction- |
Industrial
gauge coated steel |
| Operating
Environment- |
38ºF
(3ºC) to 122ºF (50ºC) |
| Substrate
Capabilities- |
Porous
and non-porous surfaces |
| Air
Requirements- |
No
external air needed |
| Ink
Capabilities- |
Porous:
Leader SQ-60™ no-clog ink
Non-Porous: Several Leader solvent
based fluids to meet adhesion and dry time needs |
| Ink
Volume- |
.5
(1.89 liters) gallon bottle standard; available
upgrade (water-base ink only) to 5.0 gallon pail
(18.93 liters) |
